music, guitars & other obsessions

DIY Pedal Power Supply

Finally got around to wire up the pedal power supply boards and put them in a case. There are 6 separate outputs, each one running off an individually regulated power supply board show here:

Tiny Regulated 9V Power Supply

I put all the boards in a small aluminum case, which can handle a few more boards, I will add them later if needed. The separate power supplies will reduce the ground loops between the pedals, which should help with noise/hum in the signal chain. The total cost for the build is around $12 which is pretty low when you consider a comparable unit from Voodoo Lab or elsewhere will run more than $100 easy!

Completed PS with Pedals

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s